dahdi_maint − Sets Dahdi spans into maintenance mode, e.g.: loopback
dahdi_maint −s num [options] dahdi_maint <−h|−−help>
dahdi_maint uses the DAHDI_MAINT interface to set a Dahdi span (port of a Dahdi adapter card) into loopback mode or similar maintenance mode.
−s −−span num
The span number. Required.
−l −−loopback <localhost|networkline|networkpayload|loopup|loopdown|off>
Loopback type. One of:
localhost
loop back towards host
networkline
network line loopback
networkpayload
network payload loopback
loopup
transmit loopup signal
loopdown
transmit loopdown signal
|
off |
end loopback mode |
−i −−insert <fas|multi|crc|cas|prbs|bipolar>
Insert an error of a specific type
Enable network line loopback on span 1:
dahdi_maint -s 1 --loopback networkline
Disable network line loopback on span 1:
dahdi_maint -s 1 --loopback off
dahdi_tool(8), dahdi_cfg(8), asterisk(8).
This manual page was written by Tzafrir Cohen <tzafrir.cohen@xorcom.com>. Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation.